Mar 23 2022
Classification of Fiber Conventers
Optical modules are divided into gigabit single-mode single-fiber modules and gigabit dual-fiber modules. The gigabit dual-fiber module has two interfaces, one for transmitting and one for receiving. Usually the interface is an LC interface, which is connected by two jumpers; The optical fiber module has only one interface, and the transceiver is integrated. The SC interface and the LC interface are mostly used, which are connected by a single-mode jumper. The gigabit single-mode single-fiber optical module needs to be used in pairs.
1.25G Tx1490/Rx1310 10Km LC Transceiver The general model is SFP-GE-LX-SM1490-BIDI, Gigabit single-mode single-fiber optical modules are widely used in Gigabit switches, Fibre Channel, routers, servers and other network equipment. The advantage of the gigabit single-fiber bidirectional optical module compared with the gigabit dual-fiber optical module is that it can save optical fibers, because the use of the dual-fiber optical module requires two optical fibers for transmission, while the single-fiber bidirectional optical module only needs one for transmission.
| GLC-BX-D | 1000BASE-BX10-D SMF TX:1490nm/RX:1310nm 10km SFP |
| GLC-BX-D20 | 1000BASE-BX SFP BIDI 1490nm-TX/1310nm-RX 20km |
| GLC-2BX-D | 1000BASE-BX10-D TX:1490nm/RX:1310nm 10km CSFP |
| EX-SFP-GE10KT14R13 | 1000BASE SMF TX:1490nm/RX:1310nm 10km BiDi SFP |
| SFP-GE10KT14R13 | 1000BASE SMF TX:1490nm/RX:1310nm 10km SFP BIDI |
| E1MG-BXD | 1000BASE-BX10-D TX:1490nm/RX:1310nm 10km SFP |
| 10057 | 1000BASE SMF TX:1490nm/RX:1310nm 10km BIDI SFP |
| JD099B | 1000BASE-BX10-D SMF TX:1490nm/RX:1310nm 10km SFP |
| JD099A | 1000BASE-BX10-D SMF TX:1490nm/RX:1310nm 10km SFP |
| SFP-GE-LX-SM1490-BIDI | 1000BASE-BX10-D TX:1490nm/RX:1310nm 10km SFP |
Parameter | Symbol | Min | Typ. | Max | Unit |
Bit Rate | BR | 1.25 | Gb/s etc | ||
Max.Supported Link Length | Max | 10 | km |
Parameter | Symbol | Min | Typ. | Max | Unit | Ref. |
Storage Temperature | TS | -40 | 85 | ºC | ||
Storage Ambient Humidity | HA | 5 | 95 | % | ||
Power Supply Voltage | VCC | -0.5 | 4 | V | ||
Signal Input Voltage | -0.3 | Vcc+0.3 | V | |||
Receiver Damage Threshold | +3 | dBm | ||||
Lead Soldering Temperature/Time | Told | 260/10 | ºC/sec | Note 1 | ||
Lead Soldering Temperature/Time | Told | 360/10 | ºC/sec | Note 2 |
Notes:
1. Suitable for wave soldering.
2. Only for soldering by iron.
